Senin, 16 Mei 2011

How to Replace a Fuel Filter in a Toyota Tacoma

How to Replace a Fuel Filter in a Toyota Tacoma

The fuel filter in your Toyota Tacoma prevents dirt and sediment from entering the fuel system. Keeping the fuel system clean is important, as even small pieces of debris could clog an injector and cause serious problems with engine performance. Follow the instructions below to replace the fuel filter in a Toyota Tacoma made between 2001 and 2005.

Difficulty:
Moderate

Instructions

things you'll need:

  • Fuel container
  • Wrenches
  • Plugs for fuel lines
  • New fuel filter
  • Gaskets
    • 1

      Relieve the fuel system pressure by first placing a container under the fuel filter. Slowly loosen a joint with the correct size wrench and a backup wrench, if necessary. Let the fuel from the fuel line slowly empty into the container. Once it all runs out, you can fully disconnect the joint.

    • 2

      Disconnect the negative battery cable. Locate the fuel filter in the engine compartment at the inlet line to the fuel rail. Remove the filter inlet and outlet lines and plug them to prevent any remaining fuel from leaking out, or dirt from entering the system.

    • 3

      Take out the fuel filter and remove it from the bracket. Place the new fuel filter in the bracket. Install the filter in the vehicle and tighten the bolts to 14 ft-lbs. Install new gaskets and tighten the union bolts to 22 ft-lbs.

    • 4

      Reconnect the negative battery cable. Start the engine of your Toyota Tacoma and check for leaks, which you'll want to repair immediately.

Tips & Warnings

  • Always let the pressure out of the fuel system before you attempt to replace the fuel filter. Do this carefully so fuel is not sprayed on your skin or eyes.

  • Make sure to wipe up any fuel that may have spilled on the vehicle before starting it.

Tidak ada komentar:

Posting Komentar